Antox 73 E Plus

Application method

icon stetec

spray

Treatment time [min.]

icon cas

30 - 90

Coverage rate [1 kg]

icon vydatnost

3 - 6 m²

Amount [kg]

baleni

10, 20, 200

 

Pickling gel for alloyed stainless steels with increased effectiveness

Compliant with the Kraftwerk Union (KWU) requirements for use in nuclear power engineering.

Scope of application

Removing weld scales and temper colours, old disturbed passive layers, carbon steel deposits, oxides of other materials, and marks caused by handling and damage caused by heat and mechanical treatment of surfaces as well as welds. Ensures a metallically clean appearance of the surface. Intended for austenitic materials.

Application

Read safety instructions before use. Stir Antox 73 E Plus well until homogeneous. Apply using a spray bottle or spraying device, creating a consistent-thickness layer over welds and surfaces. Depending on the type of steel, the weld type and ambient temperature, allow to act for 30–90 minutes. Rinse with min. 12 MPa pressure water. Keep rinsing until the pickled surface and rinse water are pH neutral. If the pickled surface is not completely clean, repeat the entire process. Sometimes it is better to pickle only the welds first before pickling the entire area.

Waste water disposal

Since rinse waste water is acidic and contains heavy metals, it must be collected. The collected rinse water must be disposed of ecologically. Either use own waste water treatment plant (consult the plant operator) or engage a specialized company to dispose of it.

Caution

Antox 73 E Plus contains nitric acid and hydrofluoric acid. The product label contains instructions to be adhered to. Further information is in a safety data list and is available on demand. Persons must wear a face mask with acid vapour filters, protective suit and gloves.

Coverage rate

1 kg of Antox 73 E Plus can treat an area of 3–6 m².

Packaging

Antox 73 E Plus is shipped in 10, 20 and 200 kg packages.

Warning!
Dangerous if inhaled or swallowed.
Contact causes serious skin and eye burns!

 

FIRST AID INSTRUCTIONS:

General instructions: Immediately remove clothing contaminated with the product. Do not remove the respirator mask until contaminated clothing is removed.
If inhaled: Transport the person to a place with fresh air. If the person is unconscious, place them into the recovery position, seek medical help.
In the event of skin contact: Immediately wash the affected area with water and soap and rinse thoroughly. Immediately apply Calcium Gluconate 400 solution or gel.
In the event of eye contact: Rinse out the eye with the eyelid open for several minutes using running water, seek medical help.
If swallowed: Do not induce vomiting, call in a doctor immediately. Drink plenty of water and get fresh air. Call in a doctor immediately.

R 23/24/25 Toxic by inhalation, in contact with skin, and if swallowed

R 35 Causes severe burns

R 37 Irritating to respiratory system

S 4 Keep away from living quarters

S 7/9 Keep container tightly closed and in a well-ventilated place

S 20 When using, do not eat or drink

S 23 Do not inhale spray

S 26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice

S 36/37/39 Wear suitable protective clothing, gloves and eye/face protection

S 45 In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible)

S 60 This material and its container must be disposed of as hazardous waste

Material Safety Data Sheet

picture

Are you interested in the product?
Contact us