Antox 3d

Application method

icon stetec

brush

Treatment time [min.]

icon cas

30 - 90

Coverage rate [1 kg]

icon vydatnost

40 - 90 metres of welds

Amount [kg]

baleni

2

 

Scope of application

Removing weld scales and temper colours, oxides of contaminant materials, and marks caused by handling. Especially intended for shiny and ground surfaces.

Application

Read safety instructions before use. Shake and stir Antox 3d until homogeneous. Apply using a plastic ANTOX brush, creating a consistent-thickness layer over the weld and its surrounding area. Depending on a weld type and ambient temperature, allow to act for 30–90 minutes. Rinse with min. 12 MPa pressure water. In the event of short welds, rinsing is also possible using running water while mechanically cleaning the area with a stainless steel or plastic brush or sponge. Keep rinsing until the pickled surface and rinse water are pH neutral. If the pickled surface is not completely clean, repeat the entire process.

Waste water disposal

Since rinse waste water is acidic and contains heavy metals, it must be collected. Before rinsing off pickling paste, neutralizing paste can be applied to the surface in order to neutralize the rinse water. The collected rinse water (even if neutralized) must be disposed of ecologically. Either use own waste water treatment plant (consult the plant operator) or engage a specialized company to dispose of it.

Caution

Antox 3d contains nitric acid and hydrofluoric acid. The product label contains instructions to be adhered to. Further information is in a safety data list and is available on demand. Persons must wear protective clothing, gloves, and a face shield.

Coverage rate

1 kg of Antox 3d can treat 40–90 metres of welds

Packaging

Antox 3d is shipped in 2 kg packages

Warning!
Dangerous if inhaled or swallowed.
Contact causes serious skin and eye damage!

 

FIRST AID INSTRUCTIONS:

General instructions: Immediately remove clothing contaminated with the product. Symptoms of poisoning need not become apparent until after many hours, so medical supervision is required for 48 hours after exposure.
If inhaled: Fresh air, oxygen supply, keep warm. If troubles persist, seek medical advice. If the person is unconscious, place them into the recovery position and transport them to a doctor.
In the event of skin contact: Immediately wash the affected area with water and soap and rinse thoroughly.
In the event of eye contact: Rinse out the eye with the eyelid open for several minutes using running water, and immediately seek medical advice and help.
If swallowed: Seek medical help immediately. Drink plenty of water and get fresh air. Do not induce vomiting, call in a doctor immediately.

R 20/21/22 Harmful by inhalation, in contact with skin, and if swallowed

R 35 Causes severe burns

R 37 Irritating to respiratory system

S 9 Keep container in a well-ventilated place

S 20 When using, do not eat or drink

S 23 Do not breathe spray, vapour

S 26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice

S 36/37/39 Wear suitable protective clothing, gloves and eye/face protection

S 45 In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible)

S 60 This material and its container must be disposed of as hazardous waste

Material Safety Data Sheet

picture

Are you interested in the product?
Contact us